Compare conductors and insulators, series and parallel circuits, switches, fuses and circuit symbols. Review suitability for your learners before teaching.
Choose “Save as PDF” to keep a copy. Use your browser’s paper setting for A4 or Letter.
Worksheet StudioPractice pack · Ages 7-9
Conductors, insulators & circuits
Take your time. Show your thinking.
1. For an electric current to flow and light up a bulb, what kind of path must the circuit form from one terminal of the battery to the other: a complete (closed) loop with no gaps, or a broken (open) loop?
Cell (+) ── Switch ── (−) · Closed Series Loop
2. In a simple SERIES circuit containing one battery and two bulbs, if you add a third identical bulb in the same single loop, what happens to the brightness of the bulbs: they become dimmer because the voltage is shared and total resistance increases, or they become three times brighter?
Cell (+) ── Switch ── (−) · Closed Series Loop
3. What happens if two identical cells in a torch are put in facing opposite directions (+ touching +): their voltages cancel out and the bulb will not light, or the bulb shines twice as bright?
Cell (+) ── Switch ── (−) · Closed Series Loop
4. What component has a resistance that decreases when brighter light shines on it (used in automatic street lights): a light-dependent resistor (LDR) or a thermistor?
Cell (+) ── Switch ── (−) · Closed Series Loop
5. In a simple SERIES circuit with two bulbs in a single loop, if one bulb’s filament breaks (blows), what happens to the other bulb: it goes out too because the single circuit loop is broken, or it stays lit?
Cell (+) ── Switch ── (−) · Closed Series Loop
6. Why are the lights and sockets in a home wired in PARALLEL rather than in series: each light is on its own branch so it receives full voltage and can be switched on or off independently without turning off the others, or parallel uses no wire?
Cell (+) ── Switch ── (−) · Closed Series Loop
7. In a standard circuit diagram, what component is represented by a circle with an “X” (cross) inside it: a filament lamp (bulb) or a battery?
Cell (+) ── Switch ── (−) · Closed Series Loop
8. Which circuit instrument is connected IN PARALLEL across a component to measure the potential difference (voltage) in volts (V): a voltmeter or an ammeter?
Cell (+) ── Switch ── (−) · Closed Series Loop
9. What safety device inside a plug or fusebox contains a thin wire designed to melt and break the circuit if the current becomes dangerously high: a fuse or a motor?
Cell (+) ── Switch ── (−) · Closed Series Loop
10. In a series circuit, how does the electric current measured at different points around the single loop compare: the current is the SAME at every point in a series loop, or it gets used up by the bulb?
Cell (+) ── Switch ── (−) · Closed Series Loop
11. What circuit component allows current to flow in ONE direction only (and emits light when it is an LED): a diode (or light-emitting diode) or a fixed resistor?
Cell (+) ── Switch ── (−) · Closed Series Loop
12. Which non-metal form of carbon (used in pencil leads) is an exception because it DOES conduct electricity: graphite or rubber?
Cell (+) ── Switch ── (−) · Closed Series Loop
12 questions · Seed 105001 · Age guidance, not curriculum certification
Worksheet StudioPractice pack · Ages 7-9
Conductors, insulators & circuits
Take your time. Show your thinking.
1. For an electric current to flow and light up a bulb, what kind of path must the circuit form from one terminal of the battery to the other: a complete (closed) loop with no gaps, or a broken (open) loop?
Cell (+) ── Switch ── (−) · Closed Series Loop
2. In a simple SERIES circuit containing one battery and two bulbs, if you add a third identical bulb in the same single loop, what happens to the brightness of the bulbs: they become dimmer because the voltage is shared and total resistance increases, or they become three times brighter?
Cell (+) ── Switch ── (−) · Closed Series Loop
3. What happens if two identical cells in a torch are put in facing opposite directions (+ touching +): their voltages cancel out and the bulb will not light, or the bulb shines twice as bright?
Cell (+) ── Switch ── (−) · Closed Series Loop
4. What component has a resistance that decreases when brighter light shines on it (used in automatic street lights): a light-dependent resistor (LDR) or a thermistor?
Cell (+) ── Switch ── (−) · Closed Series Loop
5. In a simple SERIES circuit with two bulbs in a single loop, if one bulb’s filament breaks (blows), what happens to the other bulb: it goes out too because the single circuit loop is broken, or it stays lit?
Cell (+) ── Switch ── (−) · Closed Series Loop
6. Why are the lights and sockets in a home wired in PARALLEL rather than in series: each light is on its own branch so it receives full voltage and can be switched on or off independently without turning off the others, or parallel uses no wire?
Cell (+) ── Switch ── (−) · Closed Series Loop
7. In a standard circuit diagram, what component is represented by a circle with an “X” (cross) inside it: a filament lamp (bulb) or a battery?
Cell (+) ── Switch ── (−) · Closed Series Loop
8. Which circuit instrument is connected IN PARALLEL across a component to measure the potential difference (voltage) in volts (V): a voltmeter or an ammeter?
Cell (+) ── Switch ── (−) · Closed Series Loop
9. What safety device inside a plug or fusebox contains a thin wire designed to melt and break the circuit if the current becomes dangerously high: a fuse or a motor?
Cell (+) ── Switch ── (−) · Closed Series Loop
10. In a series circuit, how does the electric current measured at different points around the single loop compare: the current is the SAME at every point in a series loop, or it gets used up by the bulb?
Cell (+) ── Switch ── (−) · Closed Series Loop
11. What circuit component allows current to flow in ONE direction only (and emits light when it is an LED): a diode (or light-emitting diode) or a fixed resistor?
Cell (+) ── Switch ── (−) · Closed Series Loop
12. Which non-metal form of carbon (used in pencil leads) is an exception because it DOES conduct electricity: graphite or rubber?
Cell (+) ── Switch ── (−) · Closed Series Loop
12 questions · Seed 105001 · Age guidance, not curriculum certification
Worksheet StudioAnswer key · Ages 7-9
Conductors, insulators & circuits
Answers and reasoning. Review before teaching.
1. For an electric current to flow and light up a bulb, what kind of path must the circuit form from one terminal of the battery to the other: a complete (closed) loop with no gaps, or a broken (open) loop?
A complete (closed) loop with no gaps
Current only flows around a continuous, closed conducting pathway.
2. In a simple SERIES circuit containing one battery and two bulbs, if you add a third identical bulb in the same single loop, what happens to the brightness of the bulbs: they become dimmer because the voltage is shared and total resistance increases, or they become three times brighter?
They become dimmer because the voltage is shared and total resistance increases
In a series loop, adding more bulbs increases resistance and splits the battery voltage across more components.
3. What happens if two identical cells in a torch are put in facing opposite directions (+ touching +): their voltages cancel out and the bulb will not light, or the bulb shines twice as bright?
Their voltages cancel out and the bulb will not light
Cells in series must be aligned positive-to-negative so their voltages add together.
4. What component has a resistance that decreases when brighter light shines on it (used in automatic street lights): a light-dependent resistor (LDR) or a thermistor?
Light-dependent resistor (LDR)
In bright light an LDR’s resistance falls; in darkness its resistance rises.
5. In a simple SERIES circuit with two bulbs in a single loop, if one bulb’s filament breaks (blows), what happens to the other bulb: it goes out too because the single circuit loop is broken, or it stays lit?
It goes out too because the single circuit loop is broken
A break anywhere in a series loop stops current throughout the entire loop.
6. Why are the lights and sockets in a home wired in PARALLEL rather than in series: each light is on its own branch so it receives full voltage and can be switched on or off independently without turning off the others, or parallel uses no wire?
Each light is on its own branch so it receives full voltage and can be switched on or off independently without turning off the others
In a parallel circuit, if one lamp fails or is switched off, current still flows through the other branches.
7. In a standard circuit diagram, what component is represented by a circle with an “X” (cross) inside it: a filament lamp (bulb) or a battery?
Filament lamp (bulb)
A circle containing a cross is the standard circuit symbol for an indicator or lighting lamp.
8. Which circuit instrument is connected IN PARALLEL across a component to measure the potential difference (voltage) in volts (V): a voltmeter or an ammeter?
Voltmeter
A voltmeter has very high resistance and is connected across (in parallel with) a component.
9. What safety device inside a plug or fusebox contains a thin wire designed to melt and break the circuit if the current becomes dangerously high: a fuse or a motor?
Fuse
If a fault causes excessive current, the fuse wire melts, cutting off the electricity to prevent overheating and fire.
10. In a series circuit, how does the electric current measured at different points around the single loop compare: the current is the SAME at every point in a series loop, or it gets used up by the bulb?
The current is the SAME at every point in a series loop
Charge is conserved—the same number of coulombs per second passes every point in a single loop; energy is transferred, not current used up.
11. What circuit component allows current to flow in ONE direction only (and emits light when it is an LED): a diode (or light-emitting diode) or a fixed resistor?
Diode (or light-emitting diode)
A diode has low resistance in the forward direction and very high resistance in reverse.
12. Which non-metal form of carbon (used in pencil leads) is an exception because it DOES conduct electricity: graphite or rubber?
Graphite
Graphite has delocalised electrons between its carbon layers, allowing it to conduct electricity.
12 questions · Seed 105001 · Age guidance, not curriculum certification