Small practice. Bright discoveries.Explore the free starter collection
Back to worksheets
ScienceAges 7-9

Conductors, insulators & circuits

Compare conductors and insulators, series and parallel circuits, switches, fuses and circuit symbols. Review suitability for your learners before teaching.

New variationTry interactive challengeBrowse templates

Choose “Save as PDF” to keep a copy. Use your browser’s paper setting for A4 or Letter.

Worksheet StudioPractice pack · Ages 7-9

Conductors, insulators & circuits

Take your time. Show your thinking.

  1. 1. In a series circuit, how does the electric current measured at different points around the single loop compare: the current is the SAME at every point in a series loop, or it gets used up by the bulb?

    +−R
    Cell (+) ── Switch ── (−) · Closed Series Loop
  2. 2. Which non-metal form of carbon (used in pencil leads) is an exception because it DOES conduct electricity: graphite or rubber?

    +−R
    Cell (+) ── Switch ── (−) · Closed Series Loop
  3. 3. What safety device inside a plug or fusebox contains a thin wire designed to melt and break the circuit if the current becomes dangerously high: a fuse or a motor?

    +−R
    Cell (+) ── Switch ── (−) · Closed Series Loop
  4. 4. What happens when you open (turn off) a switch in a simple series circuit: it creates a gap (open circuit) that stops the current flowing and turns the bulb off, or it makes the bulb brighter?

    +−R
    Cell (+) ── Switch ── (−) · Closed Series Loop
  5. 5. What is the role of the cell or battery in an electrical circuit: it provides the electrical energy (potential difference / voltage) that pushes charges around the circuit, or it absorbs light?

    +−R
    Cell (+) ── Switch ── (−) · Closed Series Loop
  6. 6. Why are the lights and sockets in a home wired in PARALLEL rather than in series: each light is on its own branch so it receives full voltage and can be switched on or off independently without turning off the others, or parallel uses no wire?

    +−R
    Cell (+) ── Switch ── (−) · Closed Series Loop
  7. 7. In a simple SERIES circuit containing one battery and two bulbs, if you add a third identical bulb in the same single loop, what happens to the brightness of the bulbs: they become dimmer because the voltage is shared and total resistance increases, or they become three times brighter?

    +−R
    Cell (+) ── Switch ── (−) · Closed Series Loop
  8. 8. Why should you NEVER touch mains electrical switches, plugs or sockets with wet hands: tap water contains dissolved salts (ions) that conduct electricity and can cause a dangerous electric shock, or water freezes the switch?

    +−R
    Cell (+) ── Switch ── (−) · Closed Series Loop
  9. 9. What circuit component allows current to flow in ONE direction only (and emits light when it is an LED): a diode (or light-emitting diode) or a fixed resistor?

    +−R
    Cell (+) ── Switch ── (−) · Closed Series Loop
  10. 10. In a standard circuit diagram, what component is represented by a circle with the letter “M” inside it: an electric motor or a buzzer?

    +−R
    Cell (+) ── Switch ── (−) · Closed Series Loop
  11. 11. Materials such as plastic, rubber, glass and dry wood that do NOT allow electric current to flow through them are called: electrical insulators or electrical conductors?

    +−R
    Cell (+) ── Switch ── (−) · Closed Series Loop
  12. 12. In a parallel circuit, how does the total current leaving the battery compare to the currents in the individual parallel branches: the total current equals the sum of the currents in the branches, or the total current is zero?

    +−R
    Cell (+) ── Switch ── (−) · Closed Series Loop
12 questions · Seed 104773 · Age guidance, not curriculum certification
View the answer key
Worksheet StudioAnswer key · Ages 7-9

Conductors, insulators & circuits

Answers and reasoning. Review before teaching.

  1. 1. In a series circuit, how does the electric current measured at different points around the single loop compare: the current is the SAME at every point in a series loop, or it gets used up by the bulb?

    The current is the SAME at every point in a series loop

    Charge is conserved—the same number of coulombs per second passes every point in a single loop; energy is transferred, not current used up.

  2. 2. Which non-metal form of carbon (used in pencil leads) is an exception because it DOES conduct electricity: graphite or rubber?

    Graphite

    Graphite has delocalised electrons between its carbon layers, allowing it to conduct electricity.

  3. 3. What safety device inside a plug or fusebox contains a thin wire designed to melt and break the circuit if the current becomes dangerously high: a fuse or a motor?

    Fuse

    If a fault causes excessive current, the fuse wire melts, cutting off the electricity to prevent overheating and fire.

  4. 4. What happens when you open (turn off) a switch in a simple series circuit: it creates a gap (open circuit) that stops the current flowing and turns the bulb off, or it makes the bulb brighter?

    It creates a gap (open circuit) that stops the current flowing and turns the bulb off

    A switch controls a circuit by safely opening or closing the conducting gap.

  5. 5. What is the role of the cell or battery in an electrical circuit: it provides the electrical energy (potential difference / voltage) that pushes charges around the circuit, or it absorbs light?

    It provides the electrical energy (potential difference / voltage) that pushes charges around the circuit

    A cell converts stored chemical energy into electrical energy.

  6. 6. Why are the lights and sockets in a home wired in PARALLEL rather than in series: each light is on its own branch so it receives full voltage and can be switched on or off independently without turning off the others, or parallel uses no wire?

    Each light is on its own branch so it receives full voltage and can be switched on or off independently without turning off the others

    In a parallel circuit, if one lamp fails or is switched off, current still flows through the other branches.

  7. 7. In a simple SERIES circuit containing one battery and two bulbs, if you add a third identical bulb in the same single loop, what happens to the brightness of the bulbs: they become dimmer because the voltage is shared and total resistance increases, or they become three times brighter?

    They become dimmer because the voltage is shared and total resistance increases

    In a series loop, adding more bulbs increases resistance and splits the battery voltage across more components.

  8. 8. Why should you NEVER touch mains electrical switches, plugs or sockets with wet hands: tap water contains dissolved salts (ions) that conduct electricity and can cause a dangerous electric shock, or water freezes the switch?

    Tap water contains dissolved salts (ions) that conduct electricity and can cause a dangerous electric shock

    Impure water is an electrical conductor and lowers the electrical resistance of skin.

  9. 9. What circuit component allows current to flow in ONE direction only (and emits light when it is an LED): a diode (or light-emitting diode) or a fixed resistor?

    Diode (or light-emitting diode)

    A diode has low resistance in the forward direction and very high resistance in reverse.

  10. 10. In a standard circuit diagram, what component is represented by a circle with the letter “M” inside it: an electric motor or a buzzer?

    Electric motor

    A circle with an “M” represents an electric motor that converts electrical energy into kinetic rotation.

  11. 11. Materials such as plastic, rubber, glass and dry wood that do NOT allow electric current to flow through them are called: electrical insulators or electrical conductors?

    Electrical insulators

    Insulators have tightly bound electrons and block the flow of electric current.

  12. 12. In a parallel circuit, how does the total current leaving the battery compare to the currents in the individual parallel branches: the total current equals the sum of the currents in the branches, or the total current is zero?

    The total current equals the sum of the currents in the branches

    By Kirchhoff’s current law (conservation of charge), current splits at a junction and recombines on return.

12 questions · Seed 104773 · Age guidance, not curriculum certification