Compare conductors and insulators, series and parallel circuits, switches, fuses and circuit symbols. Review suitability for your learners before teaching.
Choose “Save as PDF” to keep a copy. Use your browser’s paper setting for A4 or Letter.
Worksheet StudioPractice pack · Ages 7-9
Conductors, insulators & circuits
Take your time. Show your thinking.
1. What happens if two identical cells in a torch are put in facing opposite directions (+ touching +): their voltages cancel out and the bulb will not light, or the bulb shines twice as bright?
Cell (+) ── Switch ── (−) · Closed Series Loop
2. What is the role of the cell or battery in an electrical circuit: it provides the electrical energy (potential difference / voltage) that pushes charges around the circuit, or it absorbs light?
Cell (+) ── Switch ── (−) · Closed Series Loop
3. What component has a resistance that decreases when brighter light shines on it (used in automatic street lights): a light-dependent resistor (LDR) or a thermistor?
Cell (+) ── Switch ── (−) · Closed Series Loop
4. In a simple SERIES circuit containing one battery and two bulbs, if you add a third identical bulb in the same single loop, what happens to the brightness of the bulbs: they become dimmer because the voltage is shared and total resistance increases, or they become three times brighter?
Cell (+) ── Switch ── (−) · Closed Series Loop
5. In a series circuit, how does the electric current measured at different points around the single loop compare: the current is the SAME at every point in a series loop, or it gets used up by the bulb?
Cell (+) ── Switch ── (−) · Closed Series Loop
6. Why should you NEVER touch mains electrical switches, plugs or sockets with wet hands: tap water contains dissolved salts (ions) that conduct electricity and can cause a dangerous electric shock, or water freezes the switch?
Cell (+) ── Switch ── (−) · Closed Series Loop
7. What safety device inside a plug or fusebox contains a thin wire designed to melt and break the circuit if the current becomes dangerously high: a fuse or a motor?
Cell (+) ── Switch ── (−) · Closed Series Loop
8. Why are the lights and sockets in a home wired in PARALLEL rather than in series: each light is on its own branch so it receives full voltage and can be switched on or off independently without turning off the others, or parallel uses no wire?
Cell (+) ── Switch ── (−) · Closed Series Loop
9. In a simple SERIES circuit with two bulbs in a single loop, if one bulb’s filament breaks (blows), what happens to the other bulb: it goes out too because the single circuit loop is broken, or it stays lit?
Cell (+) ── Switch ── (−) · Closed Series Loop
10. Which non-metal form of carbon (used in pencil leads) is an exception because it DOES conduct electricity: graphite or rubber?
Cell (+) ── Switch ── (−) · Closed Series Loop
11. In a parallel circuit, how does the total current leaving the battery compare to the currents in the individual parallel branches: the total current equals the sum of the currents in the branches, or the total current is zero?
Cell (+) ── Switch ── (−) · Closed Series Loop
12. Materials such as copper, aluminium, silver and steel that allow electric current to flow through them easily are called: electrical conductors or electrical insulators?
Cell (+) ── Switch ── (−) · Closed Series Loop
12 questions · Seed 104729 · Age guidance, not curriculum certification
View the answer key
Worksheet StudioAnswer key · Ages 7-9
Conductors, insulators & circuits
Answers and reasoning. Review before teaching.
1. What happens if two identical cells in a torch are put in facing opposite directions (+ touching +): their voltages cancel out and the bulb will not light, or the bulb shines twice as bright?
Their voltages cancel out and the bulb will not light
Cells in series must be aligned positive-to-negative so their voltages add together.
2. What is the role of the cell or battery in an electrical circuit: it provides the electrical energy (potential difference / voltage) that pushes charges around the circuit, or it absorbs light?
It provides the electrical energy (potential difference / voltage) that pushes charges around the circuit
A cell converts stored chemical energy into electrical energy.
3. What component has a resistance that decreases when brighter light shines on it (used in automatic street lights): a light-dependent resistor (LDR) or a thermistor?
Light-dependent resistor (LDR)
In bright light an LDR’s resistance falls; in darkness its resistance rises.
4. In a simple SERIES circuit containing one battery and two bulbs, if you add a third identical bulb in the same single loop, what happens to the brightness of the bulbs: they become dimmer because the voltage is shared and total resistance increases, or they become three times brighter?
They become dimmer because the voltage is shared and total resistance increases
In a series loop, adding more bulbs increases resistance and splits the battery voltage across more components.
5. In a series circuit, how does the electric current measured at different points around the single loop compare: the current is the SAME at every point in a series loop, or it gets used up by the bulb?
The current is the SAME at every point in a series loop
Charge is conserved—the same number of coulombs per second passes every point in a single loop; energy is transferred, not current used up.
6. Why should you NEVER touch mains electrical switches, plugs or sockets with wet hands: tap water contains dissolved salts (ions) that conduct electricity and can cause a dangerous electric shock, or water freezes the switch?
Tap water contains dissolved salts (ions) that conduct electricity and can cause a dangerous electric shock
Impure water is an electrical conductor and lowers the electrical resistance of skin.
7. What safety device inside a plug or fusebox contains a thin wire designed to melt and break the circuit if the current becomes dangerously high: a fuse or a motor?
Fuse
If a fault causes excessive current, the fuse wire melts, cutting off the electricity to prevent overheating and fire.
8. Why are the lights and sockets in a home wired in PARALLEL rather than in series: each light is on its own branch so it receives full voltage and can be switched on or off independently without turning off the others, or parallel uses no wire?
Each light is on its own branch so it receives full voltage and can be switched on or off independently without turning off the others
In a parallel circuit, if one lamp fails or is switched off, current still flows through the other branches.
9. In a simple SERIES circuit with two bulbs in a single loop, if one bulb’s filament breaks (blows), what happens to the other bulb: it goes out too because the single circuit loop is broken, or it stays lit?
It goes out too because the single circuit loop is broken
A break anywhere in a series loop stops current throughout the entire loop.
10. Which non-metal form of carbon (used in pencil leads) is an exception because it DOES conduct electricity: graphite or rubber?
Graphite
Graphite has delocalised electrons between its carbon layers, allowing it to conduct electricity.
11. In a parallel circuit, how does the total current leaving the battery compare to the currents in the individual parallel branches: the total current equals the sum of the currents in the branches, or the total current is zero?
The total current equals the sum of the currents in the branches
By Kirchhoff’s current law (conservation of charge), current splits at a junction and recombines on return.
12. Materials such as copper, aluminium, silver and steel that allow electric current to flow through them easily are called: electrical conductors or electrical insulators?
Electrical conductors
Metals have free-moving (delocalised) electrons that conduct electric current readily.
12 questions · Seed 104729 · Age guidance, not curriculum certification
Worksheet StudioPractice pack · Ages 7-9
Conductors, insulators & circuits
Take your time. Show your thinking.
1. What happens if two identical cells in a torch are put in facing opposite directions (+ touching +): their voltages cancel out and the bulb will not light, or the bulb shines twice as bright?
Cell (+) ── Switch ── (−) · Closed Series Loop
2. What is the role of the cell or battery in an electrical circuit: it provides the electrical energy (potential difference / voltage) that pushes charges around the circuit, or it absorbs light?
Cell (+) ── Switch ── (−) · Closed Series Loop
3. What component has a resistance that decreases when brighter light shines on it (used in automatic street lights): a light-dependent resistor (LDR) or a thermistor?
Cell (+) ── Switch ── (−) · Closed Series Loop
4. In a simple SERIES circuit containing one battery and two bulbs, if you add a third identical bulb in the same single loop, what happens to the brightness of the bulbs: they become dimmer because the voltage is shared and total resistance increases, or they become three times brighter?
Cell (+) ── Switch ── (−) · Closed Series Loop
5. In a series circuit, how does the electric current measured at different points around the single loop compare: the current is the SAME at every point in a series loop, or it gets used up by the bulb?
Cell (+) ── Switch ── (−) · Closed Series Loop
6. Why should you NEVER touch mains electrical switches, plugs or sockets with wet hands: tap water contains dissolved salts (ions) that conduct electricity and can cause a dangerous electric shock, or water freezes the switch?
Cell (+) ── Switch ── (−) · Closed Series Loop
7. What safety device inside a plug or fusebox contains a thin wire designed to melt and break the circuit if the current becomes dangerously high: a fuse or a motor?
Cell (+) ── Switch ── (−) · Closed Series Loop
8. Why are the lights and sockets in a home wired in PARALLEL rather than in series: each light is on its own branch so it receives full voltage and can be switched on or off independently without turning off the others, or parallel uses no wire?
Cell (+) ── Switch ── (−) · Closed Series Loop
9. In a simple SERIES circuit with two bulbs in a single loop, if one bulb’s filament breaks (blows), what happens to the other bulb: it goes out too because the single circuit loop is broken, or it stays lit?
Cell (+) ── Switch ── (−) · Closed Series Loop
10. Which non-metal form of carbon (used in pencil leads) is an exception because it DOES conduct electricity: graphite or rubber?
Cell (+) ── Switch ── (−) · Closed Series Loop
11. In a parallel circuit, how does the total current leaving the battery compare to the currents in the individual parallel branches: the total current equals the sum of the currents in the branches, or the total current is zero?
Cell (+) ── Switch ── (−) · Closed Series Loop
12. Materials such as copper, aluminium, silver and steel that allow electric current to flow through them easily are called: electrical conductors or electrical insulators?
Cell (+) ── Switch ── (−) · Closed Series Loop
12 questions · Seed 104729 · Age guidance, not curriculum certification
Worksheet StudioAnswer key · Ages 7-9
Conductors, insulators & circuits
Answers and reasoning. Review before teaching.
1. What happens if two identical cells in a torch are put in facing opposite directions (+ touching +): their voltages cancel out and the bulb will not light, or the bulb shines twice as bright?
Their voltages cancel out and the bulb will not light
Cells in series must be aligned positive-to-negative so their voltages add together.
2. What is the role of the cell or battery in an electrical circuit: it provides the electrical energy (potential difference / voltage) that pushes charges around the circuit, or it absorbs light?
It provides the electrical energy (potential difference / voltage) that pushes charges around the circuit
A cell converts stored chemical energy into electrical energy.
3. What component has a resistance that decreases when brighter light shines on it (used in automatic street lights): a light-dependent resistor (LDR) or a thermistor?
Light-dependent resistor (LDR)
In bright light an LDR’s resistance falls; in darkness its resistance rises.
4. In a simple SERIES circuit containing one battery and two bulbs, if you add a third identical bulb in the same single loop, what happens to the brightness of the bulbs: they become dimmer because the voltage is shared and total resistance increases, or they become three times brighter?
They become dimmer because the voltage is shared and total resistance increases
In a series loop, adding more bulbs increases resistance and splits the battery voltage across more components.
5. In a series circuit, how does the electric current measured at different points around the single loop compare: the current is the SAME at every point in a series loop, or it gets used up by the bulb?
The current is the SAME at every point in a series loop
Charge is conserved—the same number of coulombs per second passes every point in a single loop; energy is transferred, not current used up.
6. Why should you NEVER touch mains electrical switches, plugs or sockets with wet hands: tap water contains dissolved salts (ions) that conduct electricity and can cause a dangerous electric shock, or water freezes the switch?
Tap water contains dissolved salts (ions) that conduct electricity and can cause a dangerous electric shock
Impure water is an electrical conductor and lowers the electrical resistance of skin.
7. What safety device inside a plug or fusebox contains a thin wire designed to melt and break the circuit if the current becomes dangerously high: a fuse or a motor?
Fuse
If a fault causes excessive current, the fuse wire melts, cutting off the electricity to prevent overheating and fire.
8. Why are the lights and sockets in a home wired in PARALLEL rather than in series: each light is on its own branch so it receives full voltage and can be switched on or off independently without turning off the others, or parallel uses no wire?
Each light is on its own branch so it receives full voltage and can be switched on or off independently without turning off the others
In a parallel circuit, if one lamp fails or is switched off, current still flows through the other branches.
9. In a simple SERIES circuit with two bulbs in a single loop, if one bulb’s filament breaks (blows), what happens to the other bulb: it goes out too because the single circuit loop is broken, or it stays lit?
It goes out too because the single circuit loop is broken
A break anywhere in a series loop stops current throughout the entire loop.
10. Which non-metal form of carbon (used in pencil leads) is an exception because it DOES conduct electricity: graphite or rubber?
Graphite
Graphite has delocalised electrons between its carbon layers, allowing it to conduct electricity.
11. In a parallel circuit, how does the total current leaving the battery compare to the currents in the individual parallel branches: the total current equals the sum of the currents in the branches, or the total current is zero?
The total current equals the sum of the currents in the branches
By Kirchhoff’s current law (conservation of charge), current splits at a junction and recombines on return.
12. Materials such as copper, aluminium, silver and steel that allow electric current to flow through them easily are called: electrical conductors or electrical insulators?
Electrical conductors
Metals have free-moving (delocalised) electrons that conduct electric current readily.
12 questions · Seed 104729 · Age guidance, not curriculum certification