Compare conductors and insulators, series and parallel circuits, switches, fuses and circuit symbols. Review suitability for your learners before teaching.
Choose “Save as PDF” to keep a copy. Use your browser’s paper setting for A4 or Letter.
Worksheet StudioPractice pack · Ages 10-12
Conductors, insulators & circuits
Take your time. Show your thinking.
1. In a standard circuit diagram, what component is represented by a circle with the letter “M” inside it: an electric motor or a buzzer?
Cell (+) ── Switch ── (−) · Closed Series Loop
2. In a series circuit, how does the electric current measured at different points around the single loop compare: the current is the SAME at every point in a series loop, or it gets used up by the bulb?
Cell (+) ── Switch ── (−) · Closed Series Loop
3. In a simple SERIES circuit containing one battery and two bulbs, if you add a third identical bulb in the same single loop, what happens to the brightness of the bulbs: they become dimmer because the voltage is shared and total resistance increases, or they become three times brighter?
Cell (+) ── Switch ── (−) · Closed Series Loop
4. If you add a second cell in series (pointing in the same direction, + to −) to a circuit with a single bulb, what happens to the bulb: it shines more brightly because the voltage pushing the current has doubled, or it goes out?
Cell (+) ── Switch ── (−) · Closed Series Loop
5. Why should you NEVER touch mains electrical switches, plugs or sockets with wet hands: tap water contains dissolved salts (ions) that conduct electricity and can cause a dangerous electric shock, or water freezes the switch?
Cell (+) ── Switch ── (−) · Closed Series Loop
6. What happens if two identical cells in a torch are put in facing opposite directions (+ touching +): their voltages cancel out and the bulb will not light, or the bulb shines twice as bright?
Cell (+) ── Switch ── (−) · Closed Series Loop
7. For an electric current to flow and light up a bulb, what kind of path must the circuit form from one terminal of the battery to the other: a complete (closed) loop with no gaps, or a broken (open) loop?
Cell (+) ── Switch ── (−) · Closed Series Loop
8. What happens when you open (turn off) a switch in a simple series circuit: it creates a gap (open circuit) that stops the current flowing and turns the bulb off, or it makes the bulb brighter?
Cell (+) ── Switch ── (−) · Closed Series Loop
9. In a simple SERIES circuit with two bulbs in a single loop, if one bulb’s filament breaks (blows), what happens to the other bulb: it goes out too because the single circuit loop is broken, or it stays lit?
Cell (+) ── Switch ── (−) · Closed Series Loop
10. What circuit component allows current to flow in ONE direction only (and emits light when it is an LED): a diode (or light-emitting diode) or a fixed resistor?
Cell (+) ── Switch ── (−) · Closed Series Loop
11. Why are the lights and sockets in a home wired in PARALLEL rather than in series: each light is on its own branch so it receives full voltage and can be switched on or off independently without turning off the others, or parallel uses no wire?
Cell (+) ── Switch ── (−) · Closed Series Loop
12. Materials such as plastic, rubber, glass and dry wood that do NOT allow electric current to flow through them are called: electrical insulators or electrical conductors?
Cell (+) ── Switch ── (−) · Closed Series Loop
12 questions · Seed 418 · Age guidance, not curriculum certification
Worksheet StudioPractice pack · Ages 10-12
Conductors, insulators & circuits
Take your time. Show your thinking.
1. In a standard circuit diagram, what component is represented by a circle with the letter “M” inside it: an electric motor or a buzzer?
Cell (+) ── Switch ── (−) · Closed Series Loop
2. In a series circuit, how does the electric current measured at different points around the single loop compare: the current is the SAME at every point in a series loop, or it gets used up by the bulb?
Cell (+) ── Switch ── (−) · Closed Series Loop
3. In a simple SERIES circuit containing one battery and two bulbs, if you add a third identical bulb in the same single loop, what happens to the brightness of the bulbs: they become dimmer because the voltage is shared and total resistance increases, or they become three times brighter?
Cell (+) ── Switch ── (−) · Closed Series Loop
4. If you add a second cell in series (pointing in the same direction, + to −) to a circuit with a single bulb, what happens to the bulb: it shines more brightly because the voltage pushing the current has doubled, or it goes out?
Cell (+) ── Switch ── (−) · Closed Series Loop
5. Why should you NEVER touch mains electrical switches, plugs or sockets with wet hands: tap water contains dissolved salts (ions) that conduct electricity and can cause a dangerous electric shock, or water freezes the switch?
Cell (+) ── Switch ── (−) · Closed Series Loop
6. What happens if two identical cells in a torch are put in facing opposite directions (+ touching +): their voltages cancel out and the bulb will not light, or the bulb shines twice as bright?
Cell (+) ── Switch ── (−) · Closed Series Loop
7. For an electric current to flow and light up a bulb, what kind of path must the circuit form from one terminal of the battery to the other: a complete (closed) loop with no gaps, or a broken (open) loop?
Cell (+) ── Switch ── (−) · Closed Series Loop
8. What happens when you open (turn off) a switch in a simple series circuit: it creates a gap (open circuit) that stops the current flowing and turns the bulb off, or it makes the bulb brighter?
Cell (+) ── Switch ── (−) · Closed Series Loop
9. In a simple SERIES circuit with two bulbs in a single loop, if one bulb’s filament breaks (blows), what happens to the other bulb: it goes out too because the single circuit loop is broken, or it stays lit?
Cell (+) ── Switch ── (−) · Closed Series Loop
10. What circuit component allows current to flow in ONE direction only (and emits light when it is an LED): a diode (or light-emitting diode) or a fixed resistor?
Cell (+) ── Switch ── (−) · Closed Series Loop
11. Why are the lights and sockets in a home wired in PARALLEL rather than in series: each light is on its own branch so it receives full voltage and can be switched on or off independently without turning off the others, or parallel uses no wire?
Cell (+) ── Switch ── (−) · Closed Series Loop
12. Materials such as plastic, rubber, glass and dry wood that do NOT allow electric current to flow through them are called: electrical insulators or electrical conductors?
Cell (+) ── Switch ── (−) · Closed Series Loop
12 questions · Seed 418 · Age guidance, not curriculum certification
Worksheet StudioAnswer key · Ages 10-12
Conductors, insulators & circuits
Answers and reasoning. Review before teaching.
1. In a standard circuit diagram, what component is represented by a circle with the letter “M” inside it: an electric motor or a buzzer?
Electric motor
A circle with an “M” represents an electric motor that converts electrical energy into kinetic rotation.
2. In a series circuit, how does the electric current measured at different points around the single loop compare: the current is the SAME at every point in a series loop, or it gets used up by the bulb?
The current is the SAME at every point in a series loop
Charge is conserved—the same number of coulombs per second passes every point in a single loop; energy is transferred, not current used up.
3. In a simple SERIES circuit containing one battery and two bulbs, if you add a third identical bulb in the same single loop, what happens to the brightness of the bulbs: they become dimmer because the voltage is shared and total resistance increases, or they become three times brighter?
They become dimmer because the voltage is shared and total resistance increases
In a series loop, adding more bulbs increases resistance and splits the battery voltage across more components.
4. If you add a second cell in series (pointing in the same direction, + to −) to a circuit with a single bulb, what happens to the bulb: it shines more brightly because the voltage pushing the current has doubled, or it goes out?
It shines more brightly because the voltage pushing the current has doubled
Two 1.5 V cells connected correctly in series supply 3.0 V, increasing the current through the bulb.
5. Why should you NEVER touch mains electrical switches, plugs or sockets with wet hands: tap water contains dissolved salts (ions) that conduct electricity and can cause a dangerous electric shock, or water freezes the switch?
Tap water contains dissolved salts (ions) that conduct electricity and can cause a dangerous electric shock
Impure water is an electrical conductor and lowers the electrical resistance of skin.
6. What happens if two identical cells in a torch are put in facing opposite directions (+ touching +): their voltages cancel out and the bulb will not light, or the bulb shines twice as bright?
Their voltages cancel out and the bulb will not light
Cells in series must be aligned positive-to-negative so their voltages add together.
7. For an electric current to flow and light up a bulb, what kind of path must the circuit form from one terminal of the battery to the other: a complete (closed) loop with no gaps, or a broken (open) loop?
A complete (closed) loop with no gaps
Current only flows around a continuous, closed conducting pathway.
8. What happens when you open (turn off) a switch in a simple series circuit: it creates a gap (open circuit) that stops the current flowing and turns the bulb off, or it makes the bulb brighter?
It creates a gap (open circuit) that stops the current flowing and turns the bulb off
A switch controls a circuit by safely opening or closing the conducting gap.
9. In a simple SERIES circuit with two bulbs in a single loop, if one bulb’s filament breaks (blows), what happens to the other bulb: it goes out too because the single circuit loop is broken, or it stays lit?
It goes out too because the single circuit loop is broken
A break anywhere in a series loop stops current throughout the entire loop.
10. What circuit component allows current to flow in ONE direction only (and emits light when it is an LED): a diode (or light-emitting diode) or a fixed resistor?
Diode (or light-emitting diode)
A diode has low resistance in the forward direction and very high resistance in reverse.
11. Why are the lights and sockets in a home wired in PARALLEL rather than in series: each light is on its own branch so it receives full voltage and can be switched on or off independently without turning off the others, or parallel uses no wire?
Each light is on its own branch so it receives full voltage and can be switched on or off independently without turning off the others
In a parallel circuit, if one lamp fails or is switched off, current still flows through the other branches.
12. Materials such as plastic, rubber, glass and dry wood that do NOT allow electric current to flow through them are called: electrical insulators or electrical conductors?
Electrical insulators
Insulators have tightly bound electrons and block the flow of electric current.
12 questions · Seed 418 · Age guidance, not curriculum certification