Small practice. Bright discoveries.Explore the free starter collection
Back to worksheets
ScienceAges 10-12

Conductors, insulators & circuits

Compare conductors and insulators, series and parallel circuits, switches, fuses and circuit symbols. Review suitability for your learners before teaching.

New variationTry interactive challengeBrowse templates

Choose “Save as PDF” to keep a copy. Use your browser’s paper setting for A4 or Letter.

Worksheet StudioPractice pack · Ages 10-12

Conductors, insulators & circuits

Take your time. Show your thinking.

  1. 1. In a standard circuit diagram, what component is represented by a circle with an “X” (cross) inside it: a filament lamp (bulb) or a battery?

    +−R
    Cell (+) ── Switch ── (−) · Closed Series Loop
  2. 2. In a simple SERIES circuit with two bulbs in a single loop, if one bulb’s filament breaks (blows), what happens to the other bulb: it goes out too because the single circuit loop is broken, or it stays lit?

    +−R
    Cell (+) ── Switch ── (−) · Closed Series Loop
  3. 3. Why are the lights and sockets in a home wired in PARALLEL rather than in series: each light is on its own branch so it receives full voltage and can be switched on or off independently without turning off the others, or parallel uses no wire?

    +−R
    Cell (+) ── Switch ── (−) · Closed Series Loop
  4. 4. What circuit component allows current to flow in ONE direction only (and emits light when it is an LED): a diode (or light-emitting diode) or a fixed resistor?

    +−R
    Cell (+) ── Switch ── (−) · Closed Series Loop
  5. 5. Which circuit instrument is connected IN PARALLEL across a component to measure the potential difference (voltage) in volts (V): a voltmeter or an ammeter?

    +−R
    Cell (+) ── Switch ── (−) · Closed Series Loop
  6. 6. In a simple SERIES circuit containing one battery and two bulbs, if you add a third identical bulb in the same single loop, what happens to the brightness of the bulbs: they become dimmer because the voltage is shared and total resistance increases, or they become three times brighter?

    +−R
    Cell (+) ── Switch ── (−) · Closed Series Loop
  7. 7. In a series circuit, how does the electric current measured at different points around the single loop compare: the current is the SAME at every point in a series loop, or it gets used up by the bulb?

    +−R
    Cell (+) ── Switch ── (−) · Closed Series Loop
  8. 8. Which circuit instrument is connected IN SERIES in a loop to measure the electric current in amperes (A): an ammeter or a voltmeter?

    +−R
    Cell (+) ── Switch ── (−) · Closed Series Loop
  9. 9. What is the role of the cell or battery in an electrical circuit: it provides the electrical energy (potential difference / voltage) that pushes charges around the circuit, or it absorbs light?

    +−R
    Cell (+) ── Switch ── (−) · Closed Series Loop
  10. 10. Why should you NEVER touch mains electrical switches, plugs or sockets with wet hands: tap water contains dissolved salts (ions) that conduct electricity and can cause a dangerous electric shock, or water freezes the switch?

    +−R
    Cell (+) ── Switch ── (−) · Closed Series Loop
  11. 11. If you add a second cell in series (pointing in the same direction, + to −) to a circuit with a single bulb, what happens to the bulb: it shines more brightly because the voltage pushing the current has doubled, or it goes out?

    +−R
    Cell (+) ── Switch ── (−) · Closed Series Loop
  12. 12. In a parallel circuit, how does the total current leaving the battery compare to the currents in the individual parallel branches: the total current equals the sum of the currents in the branches, or the total current is zero?

    +−R
    Cell (+) ── Switch ── (−) · Closed Series Loop
12 questions · Seed 104757 · Age guidance, not curriculum certification
View the answer key
Worksheet StudioAnswer key · Ages 10-12

Conductors, insulators & circuits

Answers and reasoning. Review before teaching.

  1. 1. In a standard circuit diagram, what component is represented by a circle with an “X” (cross) inside it: a filament lamp (bulb) or a battery?

    Filament lamp (bulb)

    A circle containing a cross is the standard circuit symbol for an indicator or lighting lamp.

  2. 2. In a simple SERIES circuit with two bulbs in a single loop, if one bulb’s filament breaks (blows), what happens to the other bulb: it goes out too because the single circuit loop is broken, or it stays lit?

    It goes out too because the single circuit loop is broken

    A break anywhere in a series loop stops current throughout the entire loop.

  3. 3. Why are the lights and sockets in a home wired in PARALLEL rather than in series: each light is on its own branch so it receives full voltage and can be switched on or off independently without turning off the others, or parallel uses no wire?

    Each light is on its own branch so it receives full voltage and can be switched on or off independently without turning off the others

    In a parallel circuit, if one lamp fails or is switched off, current still flows through the other branches.

  4. 4. What circuit component allows current to flow in ONE direction only (and emits light when it is an LED): a diode (or light-emitting diode) or a fixed resistor?

    Diode (or light-emitting diode)

    A diode has low resistance in the forward direction and very high resistance in reverse.

  5. 5. Which circuit instrument is connected IN PARALLEL across a component to measure the potential difference (voltage) in volts (V): a voltmeter or an ammeter?

    Voltmeter

    A voltmeter has very high resistance and is connected across (in parallel with) a component.

  6. 6. In a simple SERIES circuit containing one battery and two bulbs, if you add a third identical bulb in the same single loop, what happens to the brightness of the bulbs: they become dimmer because the voltage is shared and total resistance increases, or they become three times brighter?

    They become dimmer because the voltage is shared and total resistance increases

    In a series loop, adding more bulbs increases resistance and splits the battery voltage across more components.

  7. 7. In a series circuit, how does the electric current measured at different points around the single loop compare: the current is the SAME at every point in a series loop, or it gets used up by the bulb?

    The current is the SAME at every point in a series loop

    Charge is conserved—the same number of coulombs per second passes every point in a single loop; energy is transferred, not current used up.

  8. 8. Which circuit instrument is connected IN SERIES in a loop to measure the electric current in amperes (A): an ammeter or a voltmeter?

    Ammeter

    An ammeter has very low resistance and is placed in series so all the current flows through it.

  9. 9. What is the role of the cell or battery in an electrical circuit: it provides the electrical energy (potential difference / voltage) that pushes charges around the circuit, or it absorbs light?

    It provides the electrical energy (potential difference / voltage) that pushes charges around the circuit

    A cell converts stored chemical energy into electrical energy.

  10. 10. Why should you NEVER touch mains electrical switches, plugs or sockets with wet hands: tap water contains dissolved salts (ions) that conduct electricity and can cause a dangerous electric shock, or water freezes the switch?

    Tap water contains dissolved salts (ions) that conduct electricity and can cause a dangerous electric shock

    Impure water is an electrical conductor and lowers the electrical resistance of skin.

  11. 11. If you add a second cell in series (pointing in the same direction, + to −) to a circuit with a single bulb, what happens to the bulb: it shines more brightly because the voltage pushing the current has doubled, or it goes out?

    It shines more brightly because the voltage pushing the current has doubled

    Two 1.5 V cells connected correctly in series supply 3.0 V, increasing the current through the bulb.

  12. 12. In a parallel circuit, how does the total current leaving the battery compare to the currents in the individual parallel branches: the total current equals the sum of the currents in the branches, or the total current is zero?

    The total current equals the sum of the currents in the branches

    By Kirchhoff’s current law (conservation of charge), current splits at a junction and recombines on return.

12 questions · Seed 104757 · Age guidance, not curriculum certification